93 Acura Legend Trunk Trigger
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=52216
Printed Date: June 18, 2024 at 5:10 AM
Topic: 93 Acura Legend Trunk Trigger
Posted By: sydewayz_510
Subject: 93 Acura Legend Trunk Trigger
Date Posted: March 20, 2005 at 6:20 AM
I'm currently installing the Viper 791XV on my 93 acura legend sedan.....and i pretty much got most of the wires hooked up and working properly but i'm still looking for the (-) negative trunk trigger....i've tried all the suggested wires like.....
Wht/Blk..........above the driver kick panel
Grn/Blk..........at rear harness behind driver kick panel
Blu/Blk..........at rear harness behind driver kick panel
Grn/Red........at rear harness behind driver kick panel
.........but none of these wires seems to give me the (-) negative ouput i'm looking for....its been 2days already and i really want to finish this install so i can move onto installing the 530T window modules........it would be greatly appreciated if anyone can please show me where the (-) negative trunk trigger is and also the (-) negative hood trigger....any pictures tutorial or wire diagram would be greatly appreciated...thanks in advance
Replies:
Posted By: boomer_106
Date Posted: March 20, 2005 at 6:27 AM
What I see for the hood pin is Yellow/Red located at the anti theft module. (Not sure where that's located in this vehicle hope you do) For the trunk I see GREEN/ black at the plug on back of the cluster. Good luck. Let us know
Posted By: sydewayz_510
Date Posted: March 20, 2005 at 2:07 PM
i was wondering if i can access the (-) negative trunk trigger from anywhere else besides in back of the cluster.......
Posted By: swamprat323
Date Posted: March 20, 2005 at 2:14 PM
run a wire all the way back to the tunk pin itself, if all eles fails.
Posted By: boomer_106
Date Posted: March 20, 2005 at 8:42 PM
That just might be the easiest thing to do.
Posted By: sydewayz_510
Date Posted: March 20, 2005 at 9:38 PM
Finally!!!..after 3days....its done....yes very ture....running a wire all the way back to the trunk pin itself will work....but i had found an easier way of getting the (-) negative trunk trigger and its located right underneth the dash....for the (-) negative trunk trigger use the BLUE/GREEN wire from the security module...well i appreciated all the advice...
|