Print Page | Close Window

Trunk release relay

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=52445
Printed Date: May 16, 2025 at 6:36 PM


Topic: Trunk release relay

Posted By: jonchos
Subject: Trunk release relay
Date Posted: March 23, 2005 at 2:16 PM

Hi, I hope any of you can help me with my trunk release wiring problem.

I recently installed a matrix 1 alarm in my car and I want to add a relay to open the trunk with the remote. My car has a factory release button, so the only thing I need is the relay, but the alarm gives a negative output and my selenoid needs a 12 volt(+) output, here is where my questions come: Can I do this with a simple 12 volt 5 pin relay? How would I conect the wires? Please help. I am not an expert in electrical wiring but I get arround somewhat. I you have a diagram it would be even better, if not, that is cool.

Jose

Thank you so much.




Replies:

Posted By: thepencil
Date Posted: March 23, 2005 at 2:32 PM
posted_image


If that doesn't make sense ask questions. Lots of expert here to help you out.



-------------
Be careful whose advice you buy, but be patient with those who supply it.posted_image



Posted By: jonchos
Date Posted: March 23, 2005 at 2:36 PM

Thank you for the lightning fast reply. This help tons!!!!

Thank you again.


Print Page | Close Window