99 Cavalier Alarm wires?

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=52567
Printed Date: June 10, 2024 at 11:31 AM

Topic: 99 Cavalier Alarm wires?

Posted By: darkspookyechos
Subject: 99 Cavalier Alarm wires?
Date Posted: March 25, 2005 at 1:45 PM

Im trying to install a Alarm in a 99 Cavalier I have all the wire diagrams but i cant find where the wire are at..

can someone please help me with this? if possible a pic of where the main wires are for the door locks and

parking lights. those are the main ones i cant find.

thanks

Shane

Replies:

Posted By: accord78
Date Posted: March 26, 2005 at 1:56 PM

CHEVROLET

MODEL YEAR(S)
CAVALIER   1995 -1999
KEY T-HARNESS IMMOBILIZER
N/A    GM-8    791 BYPASS MODULE
PART   COLOR LOCATION DIAGRAM
12 VOLT CONSTANT   RED (X2)    IGNITION SWITCH HARNESS
STARTER YELLOW (+)   IGNITION SWITCH HARNESS
STARTER 2 N/A
IGNITION 1 PINK (+) IGNITION SWITCH HARNESS
IGNITION 2 WHITE (+) IGNITION SWITCH HARNESS
IGNITION 3 N/A
ACCESSORY /HEATER BLOWER 1 ORANGE (+)   IGNITION SWITCH HARNESS
ACCESSORY /HEATER BLOWER 2 N/A
KEYSENSE N/A
PARKING LIGHTS ( - ) N/A
PARKING LIGHTS ( + ) BROWN (+)   IN DRIVERS KICK PANEL
POWER LOCK LIGHT BLUE See NOTE *1   IN EITHER KICK PANEL
POWER UNLOCK WHITE See NOTE *1   IN EITHER KICK PANEL
LOCK MOTOR WIRE
DOOR TRIGGER GREEN/ BLACK and LIGHT BLUE (-)   See NOTE *2
DOMELIGHT SUPERVISION GREEN/ BLACK and LIGHT BLUE (-)   See NOTE *2   22056_CAVALIER-_(-) NEGATIVE DOOR PIN ISOLATION CIRCUIT.pdf
TRUNK RELEASE BLACK/ WHITE (+)   @ HATCH RELEASE SWITCH
SLIDING POWER DOOR N/A
HORN BLACK (-)   @ STEERING COLUMN HARNESS
TACH PURPLE / WHITE or WHITE   IN ENGINE HARNESS
WAIT TO START LIGHT N/A
BRAKE WHITE (+)   @SW ABOVE BRAKE PEDAL
FACTORY ALARM DISARM   N/A
ANTI-THEFT YELLOW and BLACK or BLACK/ WHITE and BLACK   PASSLOCK 1 at the STEERING CLOUMN HARNESS
NOTES
NOTE *1 WITHOUT factory keyless entry, TYPE C, PASSENGER switch is the MASTER SWITCH. WITH factory keyless entry, TYPE A

NOTE *2 The DRIVERS DOOR is the GREEN/ BLACK (-) located in the LOW drivers kick panel. The PASSENGER doors is a LIGHT BLUE (-) located in the LOWER passengers kick panel and this cataches all other doors, use both wires and DIODE ISOLATE when connecting to an ALARM SYSTEM. For DOME LIGHT SUPERVISION use on the GREEN/ BLACK (-).

hope that works

Posted By: darkspookyechos
Date Posted: March 26, 2005 at 6:58 PM

That helps with what wires are what,

But i dont understaind what the kick panel is and what not. from what i can see there are 3 sets of wires in that area where i would think the panel is.

Posted By: darkspookyechos
Date Posted: March 29, 2005 at 6:35 PM

Ok from my last post I did find most of the wires I needed, for those I could not find I rigged them ;-)

Now I cant seem to get the door locks to work? could this have anything to do with the OEM alarm installed? I am not sure even if my car has a OEM alarm how can I check that out?

I just cant seem to find the right wireing for the door locks iv tryed all the ones listed in the wireing diagram I found online.

Thanks

Posted By: Chad7n7
Date Posted: March 29, 2005 at 7:02 PM

Sounds the best solution for you is to take out what you have wiRED / "rigged", and bring it to your local installer. Accord78's diagram was the easiest you will find, if you are experienced with alarms, it is self explanatory.

No offense meant by this post, I would just rather see someone have it installed and its done correctly, then someone inexperienced try, and fry something.

-------------

Posted By: darkspookyechos
Date Posted: March 29, 2005 at 9:24 PM

Its no big thing, Most of the alarm I did not use so I had to change some of the wireing around to make it work.

The wire map worked for most of it only thing i cant get to work is the door locks.