1994 mazda 626 clutch bypass

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=52649
Printed Date: May 01, 2024 at 12:39 PM

Topic: 1994 mazda 626 clutch bypass

Posted By: ayalja123
Subject: 1994 mazda 626 clutch bypass
Date Posted: March 26, 2005 at 7:13 PM

does anyone knows how to bypass the clutch on a 94 mazda 626. i try unpluging them and that didn't work. the car would not start. i also try checking the wire to see wish one would change when you press the cluch but there was only one that would ground. so i try gounding this wire and still no luck instead i had to replace a 40 amp fuse in the engine compartment.all of the other wires would stay the same.does anybody have any idea?

Replies:

Posted By: dare_ds69
Date Posted: March 28, 2005 at 7:17 AM

you have to test both wires at the clutch just tie together or use a relay.

-------------
how own your mind, control your life.
MECP certified. always use a DMM

Posted By: ayalja123
Date Posted: March 28, 2005 at 2:45 PM

THANKS BUT THAT WILL NOT WORK BECAUSE I DID TEST ALL THE WIRES ON BOTH SWITCHES AND ONLY ONE GROUNDED BUT WHEN I TRY HOOKING IT TO A GROUND IT BLOW MY FUSE. THATS THE SWITCH AT THE BOTTOM.

Posted By: amac209
Date Posted: March 28, 2005 at 10:33 PM

i would run a wire straight off the starter solenoid exciter wire or starter relay.

Posted By: dare_ds69
Date Posted: March 29, 2005 at 7:27 AM

it have to be a wire that when you press the clutch change polaryti if u use a relay it shuld blow a fuse

30 to one wire

87 to the other wire

85 negative from remote starer output

86 12v fused constant

it will do the same funtion as factory

-------------
how own your mind, control your life.
MECP certified. always use a DMM

Print Page | Close Window