Print Page | Close Window

Remote Start turns off after couple sec

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=53884
Printed Date: May 02, 2025 at 8:43 AM


Topic: Remote Start turns off after couple sec

Posted By: luis_89lxi
Subject: Remote Start turns off after couple sec
Date Posted: April 13, 2005 at 11:53 PM

Hi!

I was installing MOTORJOY GTO-PATROL security alarm and remote start on my '00 Dodge Neon SE, everything on the alarm works fine, but the problem is the remote start.

 I wired everything, hand brake, brake switch and Ignitions, when i try remote strat the car cranks and the engine fires fine, runs good for a couple seconds and then shut down.

 I try whit the BLACK/ Gray TACH signal on the DIS and does this, then try the GREEN / WHITE 12V for DIS and does same problem (even if disconnect the 12V input for Remote Start do this fail).

I made this test: If i release the hand brake or open the hood the remote start not even crank, so this inputs are fine.
 I guess the problem is the 12V input for remote start when the car is running, i migth be using the wrong cable.

 Could somebody help me out i have this NEON all striped and dont want drive that way.

2000 Dodge Neon Security Information:
Constant   12V+ Pink/Black or Red  Ignition Switch Harness 
Starter    Yellow                  Ignition Switch Harness 
Ignition   Dark Blue                Ignition Switch Harness 
Ignition 2 BLACK/ Orange             Ignition Switch Harness 
Accessory  BLACK/ Orange            Ignition Switch Harness (Heat/AC) 
Tach       BLACK/ Gray              Coil

This is the Alarm Installation diagram, if you cannot see the link, please copy and paste on adress bar:

posted_image

Thank you in advance for all your info.




Replies:

Posted By: JWorm
Date Posted: April 14, 2005 at 12:19 AM
grey key or black key?




Posted By: luis_89lxi
Date Posted: April 14, 2005 at 12:25 AM
grey key, iguess this is for Sentry systems, i there any way to bypass the sentry module ? Man i sad, i spen half of my paycheck on this and its not for my car.




Posted By: mo12v
Date Posted: April 14, 2005 at 10:00 AM
R U using a By Pass Kit?
If not...........You need a ByPass kit..........Either a Hide a Key type or a Programmable type

-------------
MO

Don't Learn from Others Mistakes
You Might Be the One That Knows.





Print Page | Close Window