Print Page | Close Window

Window module + Sunroof module

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=5403
Printed Date: August 06, 2025 at 11:19 PM


Topic: Window module + Sunroof module

Posted By: stasisnine
Subject: Window module + Sunroof module
Date Posted: November 12, 2002 at 11:28 PM

I had a DEI 530t installed to control 2 windows up/down and also a 529t to control the sunroof. These are both wired to channel 2 to open. I have to hold down the button to open it, since I realize it's a pulsed output on the 550ESP.

I have channel 4 to control all the windows to roll up. The problem is, sometimes, only the sunroof will close, leaving the windows down. The windows will inch up slowly with several presses. Do I have to set ch 4 to latched? What is the probem here?

The windows also don't close when the system is armed. Maybe the installed didn't wire up the ground when armed to the modules?

Any help is appreciated.




Replies:

Posted By: jonj0n1
Date Posted: November 20, 2002 at 3:28 PM
on the 530t theres an orange activation when armed wire that you connect with a diode to the orange wire from the starter kill relay. everytime you arm your system, that orange wire sends out a negative pulse. when the orange wire from 530t senses that signal, it will roll the windows up. so instead of wiring it up to ch 4 connect it to the orange wire from the starterkill relay with a diode.


Print Page | Close Window