Viper 791xv

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=54288
Printed Date: May 12, 2025 at 2:27 AM

Topic: Viper 791xv

Posted By: 2001svt
Subject: Viper 791xv
Date Posted: April 20, 2005 at 11:42 AM

Hello,

I was looking over the installatin guide on the 791 xv. I'm confused on the H1/3 WHITE/ blue remote start wire. Where do I connect it? I havent did an alarm install for about 7yrs. I'm a little rusty.

Thanks

Replies:

Posted By: Montrealler
Date Posted: April 20, 2005 at 7:38 PM

https://www.directechs.com/guides/manuals/ig/viper/N564V_01-05.pdf

As seen on page 18 of their guide if you did not change the factory setings if this wire receive 2 consecutive pulse of ground the remote start will engage...

Glade to diserve you !!!!!!!!!!!!11
WD-40!

Posted By: 2001svt
Date Posted: April 21, 2005 at 12:27 PM

Leaving the stock settings alone. I don't need to hook up this wire. Right?

Posted By: Smoke Signals
Date Posted: April 21, 2005 at 2:41 PM

This wire is so you could hook up a momentary switch inside the car to activate the remote start. (Never understood that since if you were in the car you could use the key).

If you want this option hook one side of the switch to this H1/3 wire, the other side to ground. Push the button twice and the remote start should activate.

Posted By: 2001svt
Date Posted: April 21, 2005 at 3:02 PM

Thanks for the info. I was confused on that one!

Posted By: Calgarysouth
Date Posted: April 21, 2005 at 3:38 PM

smoke signals.....

you are right, there is no point of having a button inside the car to start the car with.....but you could use it for a remote start timer or some other device.

Posted By: nava94
Date Posted: April 23, 2005 at 12:53 PM

i don't see the point of that either? DEI please explain.

Posted By: metaverse
Date Posted: April 23, 2005 at 11:40 PM

That wire is so you can 1) test remote start while you are installing/troubleshooting it to see if it (remote start) works. 2) to tie it into an existing system that already has an alarm/keyless entry so you don't have to carry 2 remotes. For e.g. you have a keyless entry unit that can emit pulses on a different channel which you can tie into this wire to make it start. You can also do 3) which is start button. 4) You an also tie it into a door keypad.. There are multiple uses for it..or, just don't use it..

Posted By: nava94
Date Posted: April 23, 2005 at 11:51 PM

that's kool and the gang.now that makes sense.thankz for the response metaverse.