2000 Ford Explorer Diagram please

I did a search and could not find a diagram for a 2000 Explorer.  Could someone please post up one or a link to where i can get my future diagrams.

Thanks

Alpine Guy

-------------
2003 Chevy Avalanche,Eclipse CD7000,Morel Elate 5,Adire Extremis,Alpine PDX-4.150, 15" TC-3000, 2 Alpine PDX-1.1000, 470Amp HO Alt.

https://www.the12volt.com/installbay/vehicles.asp?sort=modelu&strMake=Ford

-------------
the12volt • Support the12volt.com

DIRECTWIRE™ WIRING INFORMATION - FORD / EXPLORER / 2000 / Remote Start


12volts yellow    +   ignition harness
Starter RED / lt. blue    +   ignition harness
Second Starter          
Ignition GREEN/ purple    +   ignition harness
Notes: Two wires each at switch, both are common, only need to power 1 each during remote start.
Second Ignition          
Third Ignition          
Accessory gray / YELLOW    +   ignition harness
Notes: Two wires each at switch, both are common, only need to power 1 each during remote start.
Second Accessory BLACK/ green    +   ignition harness
Keysense          
Power Lock pink / YELLOW    -   driver kick panel
Power Unlock pink/green    -   driver kick panel
Lock Motor pink/black      driver kick panel
Unlock Motor RED / orange      driver kick panel
Parking Lights+ PURPLE / white      driver kick panel
Notes: Also found to be WHITE/ black at the rear of the switch.
Parking Lights- WHITE/ purple      driver kick panel
Hazards          
Turn Signal(L)          
Turn Signal(R)          
Reverse Light          
Door Trigger      -     
Notes: In the drivers door harness find yellow/black for the drivers door. In the drivers kick panel find lt. GREEN/ YELLOW for the drivers rear door. In the passengers kick panel find gray/red for the passenger front door, and pink/lt. blue for the passengers rear door. All four wires are negative trigger and must be diode isolated together. Refer to directfax document #1076 for wiring information.

In the drivers door harness find yellow/black for the drivers door. In the drivers kick panel find lt. GREEN/ YELLOW for the drivers rear door. In the passengers kick panel find gray/red for the passenger front door, and pink/lt. blue for the passengers rear door. All four wires are negative trigger and must be diode isolated together. Refer to directfax document #1076 for wiring information.
Dome Supervision use door trigger       
Trunk/Hatch Pin WHITE/ purple    -   driver kick panel
Hood Pin tan/lt.green    -   driver kick panel
Trunk/Hatch Release          
Power Sliding Door          
Factory Alarm Arm arms on lock       
Notes: Arms on lock only with door open. It is necessary to send a signal to door trigger as well as lock to arm factory alarm.
Factory Alarm Disarm dk. GREEN/ purple    -   driver kick panel
Disarm No Unlock          
Tachometer tan / YELLOW      PCM
Notes: The PCM is located at the top of the firewall towards the passenger side, the tan / YELLOW tach wire is also found at the back of the instrument cluster.
Wait to start          
Brake Wire lt.green    +   driver kick panel
Parking Brake          
Horn Trigger yellow/lt. green    -   steering column
Memory Seat 1          
Memory Seat 2          
Memory Seat 3          
Immobilizer Bypass Module: Required: Yes Type: PATS Part #: 555P, 555F, 556U, or 555U
Notes: N/A



      
This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.
Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.





-------------
Be careful whose advice you buy, but be patient with those who supply it.