98 Honda prelude, trunk trigger

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=54576
Printed Date: May 09, 2025 at 8:52 PM

Topic: 98 Honda prelude, trunk trigger

Posted By: kickassio
Subject: 98 Honda prelude, trunk trigger
Date Posted: April 25, 2005 at 1:42 AM

I have a 98 HOnda prelude and just swapped out the Alpine alarm that was in there and put in a Python 881XP, but my trunk pin is not working anymore. THe voltage starts at 12volts and SLOWWWLY drops to like .14 volts, wich is not good enough for ground. is theere any way that i can fix this using a relay or something. Because the trunk pin is the orange wire behind the cruise control switch and it doesnt seem to be working.

Thank you for looking.

-------------

Replies:

Posted By: floaterr
Date Posted: April 25, 2005 at 1:53 AM

Trunk Pin ORANGE / Silver Dots Driver's Kick Panel

Same wire?

Posted By: kickassio
Date Posted: April 25, 2005 at 4:51 PM

Yeah thats the same wire, only that it takes forever to drop down to .14(something low like that), maybe to a count of 5 seconds. Could it be that my trunk trigger is dirty or something like that? If so how can i clean it. But more importantly, where is it? Its just weird that it doesnt work now but it worked on my alpine alarm that i just swapped out.

Thanks for your post.

-------------

Posted By: niper0108
Date Posted: April 25, 2005 at 6:36 PM

Are you getting those readings with the alarm hooked into the trunk wire?

Posted By: kickassio
Date Posted: April 25, 2005 at 6:58 PM

No, but how would that make a difference?

-------------

Print Page | Close Window