Print Page | Close Window

Install Tecvox in Nissan Altima 2000

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=54593
Printed Date: May 10, 2025 at 5:17 PM


Topic: Install Tecvox in Nissan Altima 2000

Posted By: terrortwinn
Subject: Install Tecvox in Nissan Altima 2000
Date Posted: April 25, 2005 at 11:01 AM

I want to install a remote starter into my nissan altima 2000.  I seen the diagram, but its not enough i don't think.  The wiring in Tecvox TC-4182 and there is alot of wires... prob like 25 wires or so.  Thank you



-------------
Scorpiotwinn



Replies:

Posted By: thepencil
Date Posted: April 25, 2005 at 11:21 AM
I don't know what you are looking for, but sound like you need a wiring diagram for you vechile. That's my guess.



DIRECTWIRE™ WIRING INFORMATION - NISSAN / ALTIMA / 2000 / Remote Start


12volts WHITE/ red    +   ignition harness
Starter BLACK / YELLOW    +   ignition harness
Second Starter BLACK/ blue    +   ignition harness
Ignition BLACK/ red    +   ignition harness
Second Ignition          
Third Ignition          
Accessory BLACK/ pink    +   ignition harness
Second Accessory WHITE/ blue    +   ignition harness
Keysense          
Power Lock gray    -   smart entrance control
Notes: The smart entrance control unit is located to the right of the steering column. It is black or blue in color.
Power Unlock purple    -   smart entrance control
Notes: The smart entrance control unit is located to the right of the steering column. It is black or blue in color.
Lock Motor RED / blue      smart entrance control
Notes: The smart entrance control unit is located to the right of the steering column. It is black or blue in color.
Unlock Motor yellow      smart entrance control
Notes: The smart entrance control unit is located to the right of the steering column. It is black or blue in color.
Parking Lights+ RED / blue      steering column
Parking Lights-          
Hazards          
Turn Signal(L)          
Turn Signal(R)          
Reverse Light          
Door Trigger RED / white    -   drivers kick panel or SECU
Notes: To avoid dome light delay use RED / green for the driver door, red for the front passenger door, and RED / black for the rear doors. All 3 three wires are located at the smart entrance control unit. Must diode isolate each.
Dome Supervision use door trigger       
Trunk/Hatch Pin red or RED / blue    -   light in trunk
Hood Pin pink/black    -   smart entrance control
Notes: The smart entrance control unit is located to the right of the steering column. It is black or blue in color.
Trunk/Hatch Release ORANGE / black    -   smart entrance control
Notes: The smart entrance control unit is located to the right of the steering column. It is black or blue in color.
Power Sliding Door          
Factory Alarm Arm lt GREEN/ red    -   smart entrance control
Notes: The smart entrance control unit is located to the right of the steering column. It is black or blue in color.
Factory Alarm Disarm GREEN/ YELLOW    -   smart entrance control
Notes: The smart entrance control unit is located to the right of the steering column. It is black or blue in color.
Disarm No Unlock          
Tachometer WHITE/ black      6 pin plug at distributor
Wait to start          
Brake Wire RED / green    +   brake pedal switch
Parking Brake          
Horn Trigger brown or grn/yel    -   steering column
Memory Seat 1          
Memory Seat 2          
Memory Seat 3          
Immobilizer Bypass Module: Required: Yes Type: Transponder Part #: 556U or 555U
Notes: N/A



      
This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.
Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.





-------------
Be careful whose advice you buy, but be patient with those who supply it.posted_image





Print Page | Close Window