wiring up r/s for display
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=54609
Printed Date: May 14, 2025 at 2:07 PM
Topic: wiring up r/s for display
Posted By: mxxmikexx
Subject: wiring up r/s for display
Date Posted: April 25, 2005 at 3:33 PM
looking on some input on how to go about doing this project. We're hooking up an audiovox aps-996 and dei 554R in some of those old clifford bubble diplays so we can display to the customers how the two way function of the transmitters work. without an actual tach signal, how can i trick the units into making the remote starter function work so we can demo the remotes to customers? if you use tachless mode, doesnt the brain monitor a voltage increase in the vehicles to know the vehicle is started? I've spoken with audiovox and they said one of their engineers made a circuit to make something like this work, but im still awaiting a phone call back on that. go figure.... anyone have any ideas?????????????
-------------
Mike Battaglia
Specialized Car Audio
Bensenville IL 60106
Replies:
Posted By: 5150azn
Date Posted: April 25, 2005 at 4:20 PM
Use a relay.
30 loops to 86 and tach input on rs unit
87 loops to 85 and constant 12v
87a goes to ground to program tach then to ground when running when displaying.
I think that should work you might wanna use a high quality relay so it doesn't stick or anything.
-------------
Tell the Snap-On guy I'm not here!
|