791XV triggered zone memory

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=54766
Printed Date: May 02, 2025 at 5:59 AM

Topic: 791XV triggered zone memory

Posted By: stingray_01
Subject: 791XV triggered zone memory
Date Posted: April 28, 2005 at 7:37 AM

If a zone is triggered the led flashes to indicate the triggered zone. The problem is even when I turn the ingnition to the on position the led doesn't stop flashing. Everytime I arm and disarm it, the remote pages me saying that the zone has been triggered even though it should have been cleared. I've got the 520T battery back up installed and I'm wondering if this could somehow make the module keep it's memory. Did the person who installed the alarm stuff up somewhere? Could it be a faulty unit?

Replies:

Posted By: kgerry
Date Posted: April 28, 2005 at 5:56 PM

it should clear history when you cycle the ignition... i would recheck the install

-------------
Kevin Gerry
Certified Electronics Technician
MECP First Class Installer

Owner/Installer
Classic Car Audio
since 1979

Posted By: Teamrf
Date Posted: April 28, 2005 at 10:17 PM

Check your ignition wire. Go arm your car and try to start it. If it starts you have the wrong ignition wire.

-------------
~The Rookie~
Rookie of the year that is...
Don't let the smoke out of your equiptment..it doesn't go back in.

Posted By: stingray_01
Date Posted: April 29, 2005 at 10:34 PM

I armed the car and I turned the iginition and it started. Would this also affect the stater anti grind because I remote started it this morning and turned the ignition to the start position and the starter motor grinded. Also puting it into valet take-over the starter motor grinds.