Print Page | Close Window

viper 791xv command signal problem

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=54801
Printed Date: May 03, 2025 at 2:59 AM


Topic: viper 791xv command signal problem

Posted By: anekin007
Subject: viper 791xv command signal problem
Date Posted: April 28, 2005 at 9:42 PM

i just got my car installed with the 791xv.  everything seems to be fine.  except car does not shut off with the remote.  but mainly i cant figure out whats wrong with the lcd or alarm.  on the lcd the only thing that shows is the battery life and the unlock icon even if i press arm/disarm it is doesnt change on the lcd just stays on unlock.  even with remote start the icon for it doesnt show up.  when i press arm/disarm the transmit and receive icon flashes then the remote makes 3 beeps and flashes the signal icon on each of those 3 beeps.  according to the manual when the signal icon shows it means that a command page is transmitted but a command page is not recieved.  how do i get all my icons do show up? 




Replies:

Posted By: Teamrf
Date Posted: April 28, 2005 at 10:14 PM
Sounds like you have a bad remote...which is very common. I just sent my alarm back to DEI. They better not send me one of those LCD remotes back. I want the new one with the LEDs on it. I've gone through two of those alarms already.

-------------
~The Rookie~
Rookie of the year that is...
Don't let the smoke out of your equiptment..it doesn't go back in.


Print Page | Close Window