Hello. I am intalling aaaaan Audoivox remote starter, model AA-RS30CS, in a 2000 Ford Ranger. I have never done this before and I am lookin fo some help. I was also wondering what wires to connect to and if it would be easier to do the wire connections in the engine compatrment instead of under the dash. Thanks alot everyone. razit33
Almost all wires are accessible at the dash... no real need to have the wires go through the firewall. Here is a wiring diagram for the Ford :
| ITEM | WIRE COLOR |POL| WIRE LOCATION |
| 12V|yellow |+ |ignition harness |
| STARTER|RED / light blue |+ |ignition harness |
| IGNITION|lt. GREEN/ purple |+ |ignition harness |
| ACCESSORY|gray / YELLOW |+ |ignition harness |
| SECOND ACCESSORY|BLACK/ lt. green |+ |ignition harness |
| POWER LOCK|pink / YELLOW |- |either door harness or *1 |
| POWER UNLOCK|pink/green |- |either door harness or *1 |
| LOCK MOTOR|pink/black | |drivers door harness |
| UNLOCK MOTOR|RED / orange | |drivers door harness |
| DISARM DEFEAT|pink/orange | |passenger door harness |
| PARKING LIGHTS +|brown | |drivers kick panel |
| PARKING LIGHTS -|WHITE/ purple *1 | |drivers kick panel |
| HEADLIGHTS|RED / yellow |+ |steering column |
| DOOR TRIGGER|*2 |- |*2 |
| DOME SUPERVISION|BLACK/ lt. blue |+ |drivers kick panel |
| HOOD PIN|tan/lt. green |- |drivers kick panel |
| FCTRY ALARM ARM|arms w/ lock | | |
|FCTRY ALRM DISARM|dk. GREEN/ purple |- |drivers kick panel |
| TACHOMETER|tan/white | |ignition coil top motor *3 |
| SPEED SENSE|gray/black | |PCM on firewall *4 |
| BRAKE WIRE|lt. green |+ |drivers kick panel |
| HORN TRIGGER|yellow/lt. green |- |steering column *1 |
| WIPERS|white & dk. blu/orn |+ |wiper motor |
| LF WINDOW UP/DN|wht/blk - red |A |drivers door motor |
| RF WINDOW UP/DN|tan/lt.blu - wht/yel|A |drivers door harness |
| RADIO 12V|lt. green |+ |radio |
| RADIO GROUND|black |- |radio |
| RADIO SWITCH|yellow/black |+ |radio |
| RADIO ILLUMINATE|lt. blue/red |+ |radio |
| LF SPEAKER|blu/wht - orn/grn | |radio or speaker |
| RF SPEAKER|grn/orn - wht/grn | |radio or speaker |
| LR SPEAKER|gry/blu - tan/yel | |radio or speaker |
| RR SPEAKER|orn/red - brn/pnk | |radio or speaker |
Notes:
NOTE: This vehicle is equipped with PATS (Passive Anti Theft System). https://www.velocitymotorsport.com/security/ford_transponder.htm. *1 These wires can also be found in the drivers kick panel in the large harness to the rear only if equipped with factory security. *2 Use yellow/black for the drivers door found in the drivers door harness, and gray/red for the passenger door (and rear on the 4dr models) found in the passenger door harness. Diode isolate each wire. See direct fax document # 1076 for wiring information. There is a single wire available on models with factory security. It is lt. blue/white negative trigger found in the drivers kick in the large harness to the rear. *3 The ignition coil is located near the center of the motor on all models. Can also get tach behind the instrument cluster, the wire is tan / YELLOW. *4 Under the hood at the top of the firewall towards the passenger side. Can also get vss behind the instrument cluster.
Here are numerous posts about the installation for trouble shooting if you wish to install it yourself:
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA