Viper Alarm On/Off Parking Lights
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=54946
Printed Date: May 18, 2025 at 3:46 PM
Topic: Viper Alarm On/Off Parking Lights
Posted By: snyblu5
Subject: Viper Alarm On/Off Parking Lights
Date Posted: May 01, 2005 at 10:35 PM
i recently replace my parking bulbs on my 95 chevy tahoe, when i did this my blinkers were rapidly flashing as if i had a bad bulb,? all were working but i went ahead and replaced one random one from each side and it blinked properly. but my lights still dont flash when i set my alarm on and off? its always worked even when i first replaced the bulbs last week..just until today when i tried my blinkers and set my alarm did i notice they werent flashing? any info would be appreciated.... also ive had the alarm with remote start for 2 years with no problems its a viper alarm. not sure what model? thanx!!!!!!!!1
-------------
snyblu5
Replies:
Posted By: Velocity Motors
Date Posted: May 01, 2005 at 10:58 PM
Check to see that the fuse didn't burnout on the Viper parking light wire.
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
Posted By: snyblu5
Date Posted: May 01, 2005 at 11:01 PM
where would that be? ive checked the fuses on my truck all is good? thanks!!!
-------------
snyblu5
Posted By: Velocity Motors
Date Posted: May 01, 2005 at 11:16 PM
It will be off the Viper system ( I think WHITE wire ) near the driver's side of the dash. Look for a 10 amp ( maybe 15 ) inline and you might have to cut through some electrical tape to find it if the installer wrapped the fuse.
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
Posted By: snyblu5
Date Posted: May 01, 2005 at 11:56 PM
i looked under the driver dash and found 3 different fuses two 30 amp and one 3 amp they were fine, but the wires were red not white? also when i unlock the truck the dome lights inside light up good sign i guess? i just want the security of being able to see my truck arm/disarm with the parking lights... im so stummped????????
-------------
snyblu5
Posted By: Captanham
Date Posted: May 02, 2005 at 3:14 AM
the 30 amps are for the main auto start, not sure about the 3, probably for a relay or something,, but the wire your looking for is white, and it will have a 10 amp fuse in it,, look for a wire goign off towards your light switch or maybe off to the left of the dash to a big wire group, trace it back from the main unit, (if it's a viper, check the back of the unit to make sure the color is white, it almost always is, but it maybe brown or something.. the back of the brain box has a list of all the colors and pins) ------------- Bad Boys Customs
audio - video - security
If you use it. Suport it. Donate to the 12 volt!
Posted By: snyblu5
Date Posted: May 02, 2005 at 8:46 PM
finally i found the fuse it was a 10 amp, and it was tucked way in my dash connected to a white lead. and it was indeed blown. so its been replaced and im glad to say everything is in working order!!!! thanks again for all the help, much appreciated!!!!!!!!!
-------------
snyblu5
Posted By: Captanham
Date Posted: May 02, 2005 at 11:40 PM
no prob ------------- Bad Boys Customs
audio - video - security
If you use it. Suport it. Donate to the 12 volt!
|