Varad Led to an existing Viper Led

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=54973
Printed Date: May 15, 2025 at 9:42 PM

Topic: Varad Led to an existing Viper Led

Posted By: rcgait1
Subject: Varad Led to an existing Viper Led
Date Posted: May 02, 2005 at 11:11 AM

I have the Viper 791 and I want to add a Varad Led scanner to the existing system led. I was hoping that all I had to do was add the new scanner to the exisiting led. Is this possible? The way the existing led is set up is that it has a blue and a red wire but from research the Varad has 3 wires ( red, black and yellow). Is it possible to tap into the existing led basically in a series? If so what wires need to be tapped into what? Any help would be appreciated.

Replies:

Posted By: desh187
Date Posted: May 11, 2005 at 6:08 PM

red wire is 12 volt,black and yellow can go together to ground output when armed wire from alarm(starter disable wire).

Print Page | Close Window