Print Page | Close Window

Proximity sensor install

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=55506
Printed Date: August 30, 2025 at 2:52 AM


Topic: Proximity sensor install

Posted By: -doh-
Subject: Proximity sensor install
Date Posted: May 10, 2005 at 11:04 PM

I just bought a proximity sensor .. tring to install it on my current 1st generation compustar... unplugged the shock sensor & plugged the badboy in but no luck. its a duel zone sensor with a red & green light... the red light, lights up.. but the sensor doesnt seem to be doing its job.. I armed the alarm, waited for 1 minute & went buck on the car.. but no warning or anything..

this is my frst time tring to install a proximity sensor .. not too sure how to get this thing working. 

another question is it possible to wire the proxi sensor parallel to my shock sensor ir will i need something else?




Replies:

Posted By: Powermyster
Date Posted: May 11, 2005 at 4:27 AM
diodes think there is a diagram to do it on this site



Posted By: gcorrea
Date Posted: May 12, 2005 at 11:37 PM
your zones might be mixed up, specially if the proximity sensor is of different brand than the alarm. if you wire them in parallel diode isolate each zone.

-------------
gcorrea


Print Page | Close Window