Print Page | Close Window

Adding fuel cut to alarm/remote start?

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=56215
Printed Date: July 17, 2025 at 4:23 PM


Topic: Adding fuel cut to alarm/remote start?

Posted By: slipnfall
Subject: Adding fuel cut to alarm/remote start?
Date Posted: May 22, 2005 at 10:56 AM

Hi there,
I'm looking for suggestions for adding a fuel cut relay to my 1992 Nissan 240sx. I am installing a Clifford alarm and remote start next weekend. What's the best way to do this, and still retain remote start and alarm features(in terms of simplicity, integration into the alarm, security).

My alarm unit has an output that is enabled when the remote start is in progress: I originally though I could use this, to enable the fuel pump when remote starting(and disabled all other times). However this wouldn't work when I manually start the car. Another option was to use the factory arm output, but this wouldn't work when the car is remote started, then automatically armed...

Any ideas? I'd rather not have to flip a switch or anything like that. This is an RSX3.5 two-way system FYI.

Thanks!
-Jamie



-------------



Replies:

Posted By: profuse007
Date Posted: May 22, 2005 at 11:35 AM
use ground when arm wire to activate the fuel cut. then use a status to interrupt the ground when armed.

-------------
Houston,TX
"The two most common elements in the universe are H+ and stupidity" (Ellison).



Posted By: slipnfall
Date Posted: May 22, 2005 at 4:47 PM

Thank you, that is exactly what I was looking for.

-Jamie



-------------


Print Page | Close Window