cs-2015fm

This system now includes a Tach Finder mode to assist in locating a valid or viable tach source for your installation. Follow the Tach Finder steps to locate and /or verify a tach signal. When following the steps, the unit will begin to flash the parking lights if you have the WHITE/ Red wire connected to a valid tach source. If lights do not flash, then try another wire until you locate a tach signal that will cause the Parking lights to flash. NOTE: On some vehicles equipped with daytime running lights, it may be difficult to see any flashing parking lights. In this case your only notification will be the slight "ticking" sound coming out of the module from the on-board flashing light relay.

1. 1. Open hood (or Ground the Blue Hood Pin wire if no hood pin is installed)
2. 2. Start Engine with the key.
3. 3. Press the Program button for 2 seconds
4. 4. Lights will begin flashing if the WHITE/ Red wire is connected to a valid tach
5. 5. Once Tach is located then turn off engine and close hood to abort.
6. 6. See Tach Reference programming below.

1. 1. Open hood (Or Ground Blue wire if no hood pin installed.)
2. 2. Connect WHITE/ RED wire to a valid Tach source.
3. 3. Start engine with key.
4. 4. Press program button 5 times, then wait for 5 light flashes.
5. 5. Wait at least one second then push program button again (1) time, you should get a light flash with the button press. This unit is now at option #1-Tach Learning.
6. 6. Press the #2 Unlock Button on remote transmitter. The unit will read and program the Tach source. The lights will flash twice for confirmation.
7. 7. If lights do not flash twice for confirmation, then try another tach source or try the tach finder.