Print Page | Close Window

door pin location

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=56479
Printed Date: March 29, 2024 at 1:09 AM


Topic: door pin location

Posted By: speeddemon03
Subject: door pin location
Date Posted: May 26, 2005 at 9:57 AM

i need help locating the door pin switch for a 2003 galant

thanks



Replies:

Posted By: thepencil
Date Posted: May 26, 2005 at 10:15 AM
Try this. See if that helps.


Dome Supervision GREEN/ orange   -   pin 1,3 pin plug above fuses






DIRECTWIRE™ WIRING INFORMATION - MITSUBISHI / GALANT / 2003 / Remote Start


12volts blue / YELLOW   +   ignition harness
Starter BLACK / YELLOW   +   ignition harness
Second Starter N/A       
Ignition BLACK/ white   +   ignition harness
Second Ignition N/A       
Third Ignition N/A       
Accessory blue/red   +   ignition harness
Second Accessory blue/black   +   ignition harness
Keysense blue/red      ignition harness
Notes: This wire rests at ground, and goes to an open circuit when the key is inserted into the ignition cylinder.
Power Lock purple   -   pin 33 at ETACS ECU
Notes: The ETACS ECU is attached to the back of the fuse box.
Power Unlock lt. GREEN/ red   -   pin 34 at ETACS ECU
Notes: The ETACS ECU is attached to the back of the fuse box.
Lock Motor blue/red   5wi pin 19, 28P plug below fuses
Unlock Motor blue/black   5wi pin 22 at ETACS ECU
Notes: The ETACS ECU is attached to the back of the fuse box.
Parking Lights+ GREEN/ orange   +   pin 5, 43 pin plug in DKP
Parking Lights- N/A       
Hazards GREEN/ YELLOW   -   pin 55 at ETACS ECU
Notes: The ETACS ECU is attached to the back of the fuse box.
Turn Signal(L) GREEN/ blue   +   pin 22, 28P plug below fuses
Turn Signal(R) GREEN/ YELLOW   +   pin 27, 28P plug below fuses
Reverse Light RED / blue   +   pin 9, 43 pin plug in DKP
Door Trigger     -     
Notes: The driver door trigger and rear door trigger are in a 15 pin plug above the fuses. The driver door is lt. green in pin 6, and the rear door is ORANGE / black in pin 10. The passenger door trigger is lt. green in pin 65 at the ETACS ECU. Use all three wires and diode isolate each.

The ETACS ECU is attached to the back of the fuse box.
Dome Supervision GREEN/ orange   -   pin 1,3 pin plug above fuses
Trunk/Hatch Pin white   -   pin 37 at ETACS ECU
Notes: The ETACS ECU is attached to the back of the fuse box.
Hood Pin blue/black   -   pin 24 at ETACS ECU
Notes: The ETACS ECU is attached to the back of the fuse box.
Trunk/Hatch Release GREEN / WHITE   5wi pin 32 at ETACS ECU
Notes: The ETACS ECU is attached to the back of the fuse box.
Power Sliding Door N/A       
Factory Alarm Arm lt. GREEN/ black   -   pin 42 at ETACS ECU
Notes: The ETACS ECU is attached to the back of the fuse box.
Factory Alarm Disarm red   -   pin 25 at ETACS ECU
Notes: The ETACS ECU is attached to the back of the fuse box.
Disarm No Unlock          
Tachometer white   ac   engine speed detect conn
Notes: The engine speed detection connector is a single pin connector in the fuse/relay box under the hood.

Can also go to one of the ignition coils or the distributor assembly and use the BLACK/ blue or WHITE/ green wire.
Wait to start N/A       
Brake Wire green   +   brake pedal switch
Parking Brake YELLOW /GREEN   -   parking brake switch
Horn Trigger lt. green   -   pin 44 at ETACS ECU
Notes: The ETACS ECU is attached to the back of the fuse box.
Memory Seat 1 N/A       
Memory Seat 2 N/A       
Memory Seat 3 N/A       
Interface Module: Category:
Required:
Yes Type:
Transponder
Part #: 556U or 555U
Notes: N/A



      
This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.
Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.





-------------
Be careful whose advice you buy, but be patient with those who supply it.posted_image





Print Page | Close Window