Audiovox PRO9432FT3 on 97 Civic
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=56614
Printed Date: July 06, 2025 at 10:33 AM
Topic: Audiovox PRO9432FT3 on 97 Civic
Posted By: mudenk
Subject: Audiovox PRO9432FT3 on 97 Civic
Date Posted: May 29, 2005 at 2:56 AM
Hi all, I have Audiovox PRO-9342FT3 series alarm to be installed on 1997 civic. I have pretty much done except several wires. On the picture that is circled red, what is the "existing low current start solenoid wire" and where can I find it? And on the same place, for the output of pin #85 of the relay where it says to "+12 volts IGN/CRANK", it seems that this diagram shows that need to be connected to red wire of this alarm. Is this correct or should I connect this pin #85 to yellow wire (+12 volts switched ignition)? Help is really appreciated and thank you very much... -Mudenk-
Replies:
Posted By: mudenk
Date Posted: May 29, 2005 at 3:03 AM
Sorry, for some reason the picture didn't show up. Here's the alarm wiring. 
Posted By: oldsaint
Date Posted: May 29, 2005 at 7:34 AM
| Constant 12V+ | White | Ignition Switch Harness | | Starter | BLACK/ White | Ignition Switch Harness | | Ignition | BLACK / YELLOW | Ignition Switch Harness | | Ignition 2 | Yellow | Ignition Switch Harness | | Accessory | WHITE/ Black | Ignition Switch Harness | | Tach | Blue | Coil | | Neutral Safety Wire | BLACK/ Blue (-) | | | Brake Switch | GREEN / WHITE | Brake Switch | | Trunk Pin | Blue/Black (-) | Driver's Kick or behind Radio Light Green (-) | | Parking Lights | RED / Black (+) | Driver's Kick Panel or above Fuse Panel | | Head Lamp | RED / White left. | RED / Blue right at Steering Column | | Door Trigger | Light GREEN/ Red (-) | Anti-Theft Module behind Radio Green Connector | | Door Lock | GREEN / WHITE (-) | Above Fuse Panel or at Anti-Theft Module | | Door Unlock | GREEN/ Orange (-) | Behind Radio Green Connector | | Horn Wire | Gray (-) | Steering Column or Green Connector behind Radio | | Windows Up | LF=RED / Yellow, RF=Blue / YELLOW, LR=GREEN/ YELLOW, RR=Yellow | | Windows Down | LF=RED / Blue, RF=Blue/Orange, LR=Green, RR=YELLOW /GREEN |
Looks like your starter wire is BLACK/ white at the ignition harness. Test it first if it's the right one cut it in half and one side goes to 30 the other to 87a. The orange wire coming from the alarm is a grounded output any time the alarm is armed that is hooked to 86 as shown. Then you need power to energize the relay. This you get from a true ignition source which should be your BLACK / YELLOW wire in the ign harness. What they're saying when it shows +12volts ign/crank is you need to make sure you have power on that wire thru crank. Other word trurn the key to the on position you should have pwr then to the start or crank position and pwr should stay. HTH
Posted By: mudenk
Date Posted: June 04, 2005 at 9:21 PM
Thank you oldsaint, your explanation does make a lot of sense. I have installed this alarm at the point of locking, unlocking and basic alarm sound when the door is opened in arming mode successfully. However, I'm still not able to find the parking light cable (RED / BLACK) in my civic. So now, whenever I lock or unlock, the light doesn't turn on. Where is this RED / BLACK wire? I have been trying to find for about 1.5 hr and still can't find it. I found BLACK/ RED, but this is not this parking light when I tested it with DMM. I found another wiring diagram location from another website and it says this wire should be in grey plug above the fuse block, but there's actually no grey plug at all. Talking about the hard way, I can route this wire from my headlight or stoplight, but I'm going to hate opening up all the plastic panels on the side (below the door when the door is closed). I'm 98% done with this alarm and hope that somebody can help me out... THANK YOU SOOO MUCH!!!
|