Print Page | Close Window

mazda 3 keysense

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=56787
Printed Date: May 12, 2025 at 5:01 PM


Topic: mazda 3 keysense

Posted By: IIrjII
Subject: mazda 3 keysense
Date Posted: June 01, 2005 at 3:36 AM

Hi. I"m doin a remote start in a 2005 Mazda 3. A couple of things I am having problems with. One, the factory alarm goes off when I remote start the car. The status output is negative, but the keysense is positive. Do I just throw a relay on to reverse polarity? And another thing, when I do remote start the car, the doors unlock automatically. Instead of tagging lock and unlock from the wire, I tagged factory arm and disarm. The doors unlock and lock normally, aside from remote start. Should I disconnect the factory arm and disarm and just tag the lock/unlock wire the way it should be? Thanks Oh, and I'm using the viper 791.



Replies:

Posted By: KarTuneMan
Date Posted: June 01, 2005 at 9:31 AM

YES, on the keysence relay question.....

Im not sure about changing the lock wires....check your programing on the 791 first, to see if you can change the setting on the lock/unlock wires to NOT pulse on remote start. You would still need to trigger the factory security wires anyways....ya see.    Viper products....I tell ya!



-------------


Print Page | Close Window