Print Page | Close Window

Plymouth Door locks

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=56825
Printed Date: July 04, 2025 at 6:57 AM


Topic: Plymouth Door locks

Posted By: eagle_51
Subject: Plymouth Door locks
Date Posted: June 01, 2005 at 4:34 PM

Was wondering if anyone could help me out. Close to blowing the darn thing up! I have a 98 Plymouth Voyager. Trying to connect a Bulldog Model Deluxe 500. Most of the connections were gravy, not the power door locks. Bull says that the ply is a one wire neg sys. I found the wht/grn wire that controls the locks. If I connect a 1.5 k resistor to a jumper from lock wire to short it locks and a 250 resistor it unlocks fine. Problem is that I can't seem to figure out how to cofigure the outputs from the module. I tried one at a time. Grn/wht wire from module to 1.5 resistor to lock wire. Will not lock. Tried with blu/wht on mod. to 250 resistor to lock wire will not unlock. Bull says to wire connector as a "type A pos". I also tried a relay with resistor, no help. The unit cliks with button pushed. Bull tech will not reply to e-mails. Can you guys help out?  




Replies:

Posted By: KarTuneMan
Date Posted: June 01, 2005 at 4:45 PM
posted_image
Wire them like so.  I would prefer to use 2 relays myself.....


-------------



Posted By: eagle_51
Date Posted: June 02, 2005 at 2:29 PM
I just wanted to say thanks for the response I received to my question. You guys answered very quick and accurate. I discovered that if I had looked a little harder, I would have found the answer on your site. Thanks again. 


Print Page | Close Window