Clifford Wire Pin Number

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=56910
Printed Date: May 15, 2025 at 5:29 PM

Topic: Clifford Wire Pin Number

Posted By: rhinopower
Subject: Clifford Wire Pin Number
Date Posted: June 02, 2005 at 3:53 PM

On a 12 pin harness with the heavy AGU wires, should the number on the pin be the same as the number the wire connects to inside the brain itself as the wires are all labeled there??

The alarm in question is a solaris.

Thanks

Replies:

Posted By: rhinopower
Date Posted: June 03, 2005 at 1:55 AM

then i've not got a fooking clue!

currently with brain connected ignition is staying on permenant, as are indicator (parking lights) and the dome light, what could be causing it?? the brain was reprogrammed fresh couple of days ago?>

Posted By: Powermyster
Date Posted: June 03, 2005 at 6:01 AM

More info.

When did this happen when was the alarm installed. did you install it.

Post exactly what the problem is. Its easier on everone in the long run

Posted By: rhinopower
Date Posted: June 03, 2005 at 6:39 AM

This happened when alarm installed.

Inside the pin numbers dont correlate to the pins on the plug.

Regardless of key position ignition stays on

Parking Lights permenantly on

Dome light permenantly on

All looms are wired correctly and tested

Could it be a bad earth?

Posted By: meltingplastic
Date Posted: June 04, 2005 at 10:31 PM

make sure the negative trigger for the relay isnt being shorted out somewhere and causing the relay to flip.. so that on a malibu where an installer didnt tape the ribbon cable for the ignition wires and the accesory wire was on all the time...

-------------
Driving a Bagged, Caddied 02 s10

Print Page | Close Window