Plymouth door locks

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=56956
Printed Date: May 14, 2025 at 1:42 AM

Topic: Plymouth door locks

Posted By: eagle_51
Subject: Plymouth door locks
Date Posted: June 03, 2005 at 9:29 AM

I have installed the deluxe model 500 remote starter on my 98 plymouth voyager. I tried the schematic on your site but the locks still fail. I wired the unit up as follows: type "B" neg. trigger, BLU/WHT (unlock) with diode to a 250 ohm resistor then to the vehicle WHT/GRN then GRN/WHT (lock) with diode to a 1.5 K resistor to WHT/GRN vehicle. Locks do not function. The unit clicks, nothing happens. Any help would be appreciated.

Replies:

Posted By: draasch
Date Posted: June 03, 2005 at 10:11 AM

*** Single Wire Door Lock System, WHITE/ D GREEN Wire Requires Chassis Ground Thru A 1.5K Ohm Resistor To Lock And Chassis Ground Thru A 249 Ohm Resistor To Unlock. #217- See Single Wire Resistor Door Lock Diagram.

-------------
Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt

Posted By: KarTuneMan
Date Posted: June 03, 2005 at 10:13 AM

Have you gotten the diodes reversed...?

-------------

Posted By: eagle_51
Date Posted: June 03, 2005 at 10:27 AM

Reviewed the website schematic again and it shows:from alarm output to diode to resistor to WHT/GRN vehicle. The diode is in as diagramed. Two other wires from alarm go to vehicle grnd. I thought that by pushhing the lock/unlock button on transmitter would cause the alarm internal relay to supply the required grnd. Does not. I also metered the out put on mod. once the grnd wires are connected. They are labeled 30 to lock/unlock & 87 to grnd. Shouldn't the internal relay in mod. read an open between 30 & 87 while not energized? Once metered it reads continuity to grnd continuous.

Posted By: thepencil
Date Posted: June 03, 2005 at 12:35 PM

You may have the wrong set-up. It should look like this. Try this set-up instead.

-------------
Be careful whose advice you buy, but be patient with those who supply it. posted_image