APS 785 Pin Switch
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=56962
Printed Date: May 13, 2025 at 6:23 PM
Topic: APS 785 Pin Switch
Posted By: jhgraham
Subject: APS 785 Pin Switch
Date Posted: June 03, 2005 at 9:34 AM
I purchased a 2003 Jeep Wrangler with a Prestige 785 Alarm system installed. It does not have a Hood Pin Switch installed.
Can I install a pin switch without disconecting anything or reprograming the system. It seems simple enough to do but being a newbee I want to make sure. I have access to the wire and location.
Is the hood pin switch a good idea? I am concerned with the remote start safety issue even though the remote start switch may be toggled but accidently toggled while wotking on the car.
Any data would be appreceiated.
Replies:
Posted By: draasch
Date Posted: June 03, 2005 at 10:12 AM
yes, wire it up to a neg trigger wire....use a diode ------------- Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt
Posted By: jhgraham
Date Posted: June 03, 2005 at 11:00 AM
Thanks for the reply. Any info on Diode installation and Diode size you wish to share?
Posted By: jhgraham
Date Posted: June 09, 2005 at 5:17 AM
Thanks for your help. I connected the Hood Pin switch to the (-) Shutdown, Gray/wBlack wire that was unused and available. While I was at it, I also connected the hood pin switch to the Instant Trigger, Brown wire. All works well. I used, 1N-1.5 AMP Diodes in both connections.
|