Print Page | Close Window

rsx factory transponder ring?

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=5699
Printed Date: July 28, 2025 at 1:38 AM


Topic: rsx factory transponder ring?

Posted By: strike92901
Subject: rsx factory transponder ring?
Date Posted: November 20, 2002 at 6:23 PM

im installing an auto start on my rsx and have the immobalizer 555u and there are two ways of installing it if i do have a transponder ring on my car can you tell me what wire i have to cut to make the imobilizer work.

                                                    Thanks




Replies:

Posted By: Derek
Date Posted: November 20, 2002 at 7:40 PM

Dear  Strike,

I'm not exactly sure what you mean about cutting wire(s)? Anyways, if you do have a transponder system on the vehicle, run the BLUE wire from the 555U to the remote start systems NEGATIVE output during start, (the installation instructions may refer to it as an " active out " output) and then connect the RED wire from the 555U to the ignition 1 output from the system that your also going to run to the vehicles ignition. This is all you need to do.

Have Fun! 



-------------


Print Page | Close Window