Code Alarm security
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=57053
Printed Date: July 15, 2025 at 2:57 PM
Topic: Code Alarm security
Posted By: benny05
Subject: Code Alarm security
Date Posted: June 04, 2005 at 8:49 PM
My daughter bought a 2000 z24 that had a security/starter
system in it. However there were no remote controls with it. I purchased a 670 remote (has lcd screen on it) and
programmed it.the doors will unlock, truck will open, can read inside temp ect., but will not start the car. It honks 2 times and the parking lamps blink 4 times but will not start. Has a 555l module attached to the main control. all fuses look good, and mercury hood switch is good. what should i look for on this system to make the remote start
work. Also the red toggle switch is switched to "ON' position. Any help would be appreciated.
Replies:
Posted By: NowYaKnow
Date Posted: June 05, 2005 at 9:50 AM
4 blinks normally means you need to learn the tach signal, OR if it is in tachless blind crank mode you just have to start the car 4 times with the key so it can learn the crank time.
Mike
Posted By: benny05
Date Posted: June 05, 2005 at 6:49 PM
Thanks for the reply Mike. I did find a bad remote security toggle switch.....what a bummer...never have seen one of these switches be completely open,,,,replaced and all is fine now. P.S. metered all commections before deciding to check the bad switch though.....probably a waste of time.
|