Print Page | Close Window

1998 honda CRv, APS996A or Viper 791vx?

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=57173
Printed Date: May 12, 2025 at 3:13 PM


Topic: 1998 honda CRv, APS996A or Viper 791vx?

Posted By: norris04
Subject: 1998 honda CRv, APS996A or Viper 791vx?
Date Posted: June 06, 2005 at 3:50 PM

I have a 1998 honda Crv and I want to get a Audiovox APS996A Remote start alarm system or a Viper 791vx.

I want to know which one is betterthe audiovox APS996A or Viper 791VX, because i heard that the viper makes the starter go out quicker than the audiovox

I want to know if its easy for me (a person who has no knowledge, but has a wire diagram)to install

I want to know if i need any extra items in order to complete the installation

-------------
Norris04



Replies:

Posted By: thepencil
Date Posted: June 06, 2005 at 4:21 PM
When you go grocery shopping. You have access to all sort of food that you can make any meal you want. Is it safe to ASS-U-ME that you can cook like a first class chefposted_image.

Below is what you will need. If you can put the two together I don't see why you can not do it. Ask questions if you are not sure. Lots of Professional installer here to help you out here.





     Viper 791vx manualViper 791VX install manual







DIRECTWIRE™ WIRING INFORMATION - HONDA / CR-V / 1998 / Remote Start


[PRINT THIS PAGE]


12volts white   +   ignition harness
Starter BLACK/ white   +   ignition harness
Second Starter          
Ignition BLACK / YELLOW   +   ignition harness
Second Ignition          
Third Ignition          
Accessory yellow   +   ignition harness
Second Accessory WHITE/ black   +   ignition harness
Keysense          
Power Lock GREEN / WHITE   -   driver door harness
Notes: Must use relays to trigger the lock and unlock wires.

Also found at the green factory alarm plug located in the drivers kick panel.
Power Unlock GREEN/ orange   -   driver door harness
Notes: Must use relays to trigger the lock and unlock wires.

Also found at the green factory alarm plug located in the drivers kick panel.
Lock Motor WHITE/ red   5wi drivers kick panel
Unlock Motor blue/red   5wi drivers kick panel
Parking Lights+ RED / black   +   dash dimmer
Parking Lights- blue/red   -     
Notes: This wire only works if there is a factory alarm installed. It is at the green factory alarm plug in the driver kick.
Hazards          
Turn Signal(L)          
Turn Signal(R)          
Reverse Light GREEN/ black   +   driver kick, harness to rear
Door Trigger lt. GREEN/ red   -   drivers kick
Notes: Also found at the green factory alarm plug located in the drivers kick panel.
Dome Supervision comes on with unlock       
Trunk/Hatch Pin blue/black   -   drivers kick
Notes: Also found at the green factory alarm plug located in the drivers kick panel.
Hood Pin yellow/red or yellow   -   hood switch
Notes: Also found at the green factory alarm plug located in the drivers kick panel.
Trunk/Hatch Release yellow   +   release switch
Power Sliding Door          
Factory Alarm Arm          
Factory Alarm Disarm          
Disarm No Unlock          
Tachometer blue   ac   test connector
Notes: Found at the 2-pin tach test connector on the drivers side of the firewall.
Wait to start          
Brake Wire GREEN / WHITE   +   cruise control
Notes: The cruise control module is located in the drivers kick panel.
Parking Brake          
Horn Trigger gray   -   drivers kick
Notes: May also use blue/green at the steering column, negative trigger.
Memory Seat 1          
Memory Seat 2          
Memory Seat 3          
Interface Module: Category:
Immobilizer Bypass Required:
No Type:
N/A
Part #: N/A
Notes:



      
This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.
Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.








-------------
Be careful whose advice you buy, but be patient with those who supply it.posted_image





Print Page | Close Window