Having trouble entering programming mode

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=5743
Printed Date: June 03, 2024 at 2:09 PM

Topic: Having trouble entering programming mode

Posted By: cyoonak
Subject: Having trouble entering programming mode
Date Posted: November 21, 2002 at 9:29 PM

I installed a CS2011 Remote Start on my car, and I'm having trouble entering its programming mode. I have the ign ON and pushed the button five times, but i'm not getting a response. I was thinking of going to radio shack and buying a new push button switch to replace it. any other ideas?

what type of switch would i even look for?

Thanks

Replies:

Posted By: alarmpro
Date Posted: November 21, 2002 at 9:36 PM

Some require that the door be open in prog mode... Also test the switch before you buy another one!!!

Posted By: SOUND PRESSURE
Date Posted: November 21, 2002 at 10:01 PM

Make sure that the door trigger wire is connected properly. As alarmpro said some alarms require that the door be open in order to enter program mode.

-------------
Sound Pressure

You know you have the right amount of pressure when your eyes start to water! Now you've got Juice!

Posted By: skerr
Date Posted: November 22, 2002 at 6:23 AM

The cs-2011 requires the hood to be open to program, or to ground the blue hood pin wire if you don't have it hooked up.

-------------
Shawn

Print Page | Close Window