Print Page | Close Window

Dei 530t, 03 Dodge Ram

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=57587
Printed Date: May 09, 2025 at 1:43 PM


Topic: Dei 530t, 03 Dodge Ram

Posted By: uniball
Subject: Dei 530t, 03 Dodge Ram
Date Posted: June 13, 2005 at 1:12 AM

Hello, I'm installing a dei 530t on my 03 dodge ram it already has a dei viper 550esp installed. My question is about the GRAY wire on the light ga harness # 2. The instructions say (-) output during activation: connect this wire to optional relay (p/n 610t) to bypass sensors which may trigger the security system during operation. This wire continues to output (-) ground for 5 sec after the window motors have stopped. I have 5 of these dei relay p/n 610t installed on my truck already. I do have a starter kill relay and I'm sure one relay is for my power door locks. I have seen other peoples diagrams of their install and this wire is completely left out. So, is this GRAY wire needed and if so where should I tie it in? Thanks in advance! uniball:D



Replies:

Posted By: dare_ds69
Date Posted: June 13, 2005 at 6:00 AM
the gray wire should be use to by pass the shock sensor but U don't have to some people has so sensitive their cars that when they roll the window down or up it triggers the alarm. I have two 530t and I did't use the grey wire just put tape on the wire posted_image

-------------
how own your mind, control your life.
MECP certified. always use a DMM



Posted By: uniball
Date Posted: June 13, 2005 at 12:09 PM
Thanks for yor help!posted_image


Print Page | Close Window