Print Page | Close Window

Ford Fiesta 95 power lock wires?

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=57746
Printed Date: May 08, 2025 at 11:26 PM


Topic: Ford Fiesta 95 power lock wires?

Posted By: Danceheaven
Subject: Ford Fiesta 95 power lock wires?
Date Posted: June 15, 2005 at 12:01 PM

Hey guys

im having a few problems trying to locate power locking and power unlocking wires however on a 95 ford fiesta uk spec, should it be a negative or positive pulse on the fiestas? ive DMM on almost every wire going to the door and no one jumps out as been a pulse some are GND all the time some are 12v all the time but nothin pulses.
Some do switch to 12v from GND however but like i say they stay there until the switch is pressed to unlock / lock
but they dont pulse in any case any ideas?

About to remove door cards



Replies:

Posted By: thepencil
Date Posted: June 15, 2005 at 9:38 PM


DIRECTWIRE™ WIRING INFORMATION - FORD / FIESTA (UK) / 1996 / Keyless Entry




12volts          
Starter blk/blu or grey      ignition harness
Ignition black or green      ignition harness
Power Lock yel/blk or yel/blu    +   either kickwell
Power Unlock wht/vio or wht/grn    +   either kickwell
Lock Motor          
Unlock Motor          
Parking Lights+ blue & blu/red     at the steering column
Parking Lights-       
Hazards       
Turn Signal(L)       
Turn Signal(R)       
Door Trigger BLACK/ red    -   n/s kick panel
Dome Supervision          
Trunk/Hatch Release ORANGE / black      at the release switch
Power Sliding Door       
Factory Alarm Arm          
Factory Alarm Disarm          
Disarm No Unlock          
Horn Trigger          
Memory Seat 1       
Memory Seat 2       
Memory Seat 3       
Interface Modules: Not Available



      
This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.
Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.





-------------
Be careful whose advice you buy, but be patient with those who supply it.posted_image


Print Page | Close Window