Anyone have the wire codes for a 2000 Honda Civic? Do I need a bypass module to install a 560XV with remote start? Thanks guys.
A bypass module is not require for your car.
DIRECTWIRE™ WIRING INFORMATION - HONDA / CIVIC / 2000 / Remote Start
12volts white + ignition harness
Starter BLACK/ white + ignition harness or
Notes: In 6 pin white plug behind fuse box
Second Starter
Ignition BLACK / YELLOW + ignition harness
Second Ignition yellow + ignition harness
Third Ignition
Accessory WHITE/ black + ignition harness
Second Accessory
Keysense
Power Lock GREEN / WHITE - keyless entry module
Notes: The keyless entry module is white in color, and located in the drivers kick panel.
Power Unlock GREEN/ orange - keyless entry module
Notes: The keyless entry module is white in color, and located in the drivers kick panel.
Lock Motor WHITE/ red drivers kick panel
Unlock Motor blue/red drivers kick panel
Parking Lights+ RED / black keyless entry module
Notes: The keyless entry module is white in color, and located in the drivers kick panel.
Parking Lights-
Hazards
Turn Signal(L)
Turn Signal(R)
Reverse Light
Door Trigger lt. GREEN/ red - OEM alarm plug
Notes: The OEM alarm plug is to the right side of the steering column. The plug is green.
Dome Supervision same as doors
Trunk/Hatch Pin blue/black - OEM alarm plug
Notes: The OEM alarm plug is to the right side of the steering column. The plug is green.
Hood Pin
Trunk/Hatch Release
Power Sliding Door
Factory Alarm Arm
Factory Alarm Disarm
Disarm No Unlock
Tachometer blue test connector
Notes: Drivers side fire wall under hood in a 2 pin plug
Wait to start
Brake Wire GREEN / WHITE + brake switch
Parking Brake
Horn Trigger gray - OEM alarm plug
Notes: The OEM alarm plug is to the right side of the steering column. The plug is green.
Memory Seat 1
Memory Seat 2
Memory Seat 3
Interface Module: Category:
Immobilizer Bypass Required:
No Type:
N/A
Part #: N/A
Notes:
This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.
Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.
-------------
Be careful whose advice you buy, but be patient with those who supply it.
