Print Page | Close Window

wiring actuators n alarm problem

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=58394
Printed Date: July 20, 2025 at 7:55 AM


Topic: wiring actuators n alarm problem

Posted By: its2nv4
Subject: wiring actuators n alarm problem
Date Posted: June 26, 2005 at 2:48 PM

i have a viper alarm 350 hv, i'd put new actuators in my doors with two relays wired up.. i have a 96 cavalier 2 door car. the relays clicks one on and one off like it should.. however its not activating my actuators in my doors. i have the actuators wired thru my relays plus the door pins onto my alarm.

i have a 3 pin door lock as an accessory plug in port.. i'd followed directions in my viper dei installation guide for my alarm.. however nothing is working to activate those actuators.. my question is.. am i su ppose to wire diodes to the actutators or the door pins in the door jam? just curious am i suppose to even have my door pins in the door jams wired at all??? i dont see the need for those to be wired up if im using relays n my alarm wired to my door locks instead.i would appreciate if anybody could help me out here. i have checked all my wiring n etc - so theres no shortage or fuse blown




Replies:

Posted By: ccroadshop99031
Date Posted: June 26, 2005 at 3:17 PM

the door pins should be wired to the alarm not the doorlock (in your case actuator) relays      assuming ur using 2 wre actuators your relays should be

85) constant 12v

86) - lock/unlock output of the alarm

30) to the actuator

87a) to ground

87)to constant 12


Print Page | Close Window