Chrysler 300C Problem

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=58779
Printed Date: May 06, 2024 at 7:37 AM

Topic: Chrysler 300C Problem

Posted By: jayts95
Subject: Chrysler 300C Problem
Date Posted: July 03, 2005 at 4:26 PM

Installed a remote start in a 300c and now the cruise control does not work. Any ideas?

Replies:

Posted By: KarTuneMan
Date Posted: July 04, 2005 at 1:42 AM

did you get the right brake wire? There are 2 green and whites at the switch?

-------------

Posted By: johnmax
Date Posted: July 10, 2005 at 7:14 PM

Make sure your resistors are right. I used a DEI resistor learning module in one and it did some funny stuff. Also try not to use your status out wire to energize any of the resistance relays, work off of your ignition wires from the RS. Using the status wire causes timing issues with the powering up of the ignition, causing the problem you are having. We had one do the exact same thing. As soon as I took off the wires from the RS then the car worked fine.

Print Page | Close Window