tech wire for Toyota camry

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=59167
Printed Date: May 19, 2024 at 12:23 PM

Topic: tech wire for Toyota camry

Posted By: oasis475
Subject: tech wire for Toyota camry
Date Posted: July 10, 2005 at 3:17 PM

hey, i am trying to install valet 562t and i just wanted to know the Location of the TECH wire in 1995 camry I4.

also "Orange(ground when armed output)" wires -- should i just ground this wire??
and

WHITE/ Blue(- activation input) --- this goes into the valet switch right?

Replies:

Posted By: 349517
Date Posted: July 10, 2005 at 6:17 PM

12volts	white - WHITE/ red	+	ignition harness
Starter	BLACK/ white	+	ignition harness
Second Starter
Ignition	BLACK / YELLOW	+	ignition harness
Second Ignition	BLACK/ orange	+	ignition harness
Third Ignition
Accessory	pink/blue	+	ignition harness
Notes: Not required for remote start.
Second Accessory
Keysense
Power Lock	blue/white	-	passengers kick blue plug
Power Unlock	lt. GREEN/ red	-	passengers kick blue plug
Lock Motor
Unlock Motor
Parking Lights+	green		bottom of fuse box
Notes: In a white connector just below the fuses with the wires exiting out toward you.
Parking Lights-	green		steering column
Hazards
Turn Signal(L)
Turn Signal(R)
Reverse Light
Door Trigger	RED / white	-
Notes: Remove black plastic air duct covering the top right side of the fuse box to access a 6 pin plug containing the RED / white.
Dome Supervision
Trunk/Hatch Pin	RED / white	-	light or sw. in trunk
Notes: Tied in with the door trigger on the wagon models.
Hood Pin
Trunk/Hatch Release
Power Sliding Door
Factory Alarm Arm
Factory Alarm Disarm
Disarm No Unlock
Tachometer	black	AC	check connector
Notes: Located on the rear side of the passenger strut tower.
Wait to start
Brake Wire	GREEN / WHITE	+	bottom of fuse box
Notes: In a white connector just below the fuses with the wires exiting out toward you.
Parking Brake
Horn Trigger	GREEN/ black	-	steering column
Memory Seat 1
Memory Seat 2
Memory Seat 3

Interface Module:	Category: Immobilizer Bypass	Required: No	Type: N/A
Part #: N/A
Notes:

This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.
Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.

-------------
Jim
Best Buy MECP Mobile supervisor in store 820
jimmyb3rddegree@hotmail.com

Posted By: genehewett
Date Posted: July 10, 2005 at 6:33 PM

Do you mean Tach? Before you start installing this system you need to understand a few things. If you have not installed a remote start system this is a good first timer "if you have a good amount of security install experiance". It is pretty much stright forward and you wont need anything special like an imobileizer by pass. Good Luck.

Do not ground the orange wire. This is used to control things like starter kill, scanning LEDs, or other things that need to be turned on when the system is armed and off when its disarmed.

TOYOTA, CAMRY, 1995, Tachometer: This wire is AC voltage. The color is Black at the following location.

On the 4 cylinder motor the black wire is at the check connector located on the rear side of the passenger strut tower. On the 6 cylinder the black wire is at the ignitor located on the drivers side strut tower.

Posted By: genehewett
Date Posted: July 10, 2005 at 7:23 PM

Thats right. Sorry for that mistake. Thanks.

Posted By: KarTuneMan
Date Posted: July 10, 2005 at 8:17 PM

Welcome to the world of DEI.....where every install manual is written for someone who has ALLREADY INSTALLED a couple hundered units.....

status output, activation input............see what I mean ?

-------------

Posted By: oasis475
Date Posted: July 10, 2005 at 8:46 PM

thank you much for the info.. i found the wire

Just another quick question

valet 562t has a feature that i can control the parking lights polarity. Can i just hook up the (+) parking lights with the Green wire(+) under the fuse box??

In the manual its says that toyota are (-) parking lights... this is little confusing..

Posted By: genehewett
Date Posted: July 10, 2005 at 8:53 PM

Yes just leave the jumper like it came from the factory and it will output 12v.