Hello, I am going to try to install a alarm with remote start on my car, I have a 1995 Oldsmobile Cutlass Ciera. If anyone can give me a example diagram of how to install a alarm on this car, please post a link. Thanks for the feedback.
1995 Oldsmobile Cutlass Ciera
12V red + ignition harness
STARTER purple or yellow + ignition harness
IGNITION pink + ignition harness
ACCESSORY orange + ignition harness
TACHOMETER *1 ignition coil module
POWER LOCK lt. blue + near underdash light
POWER UNLOCK white + in 3 and 8 pin plug
PARKING LIGHTS + brown steering column
DOOR TRIGGER *2 - *2
HEADLIGHTS yellow + steering column
WIPERS dk. green + wiper switch
LF WINDOW UP/DN dk. blue - gray A drivers window motor
RF WINDOW UP/DN lt. blue - tan A in drivers door or dkp
LR WINDOW UP/DN dk. green - purple A in drivers door or dkp
RR WINDOW UP/DN lt. green - purple A in drivers door or dkp
TRUNK/HATCH PIN gray *3 - rear dome lamp
TRUNK/HATCH RELEASE black + release switch
HORN TRIGGER black - steering column
BRAKE WIRE yellow + brake switch
Notes: *1 Use white or orange on the 4 cylinder motor, and PURPLE / white on the 6 cylinder motor. *2 Must go to each door to avoid dome light delay and/or alarm falsing from the dome light check circuit. For the drivers door, use Lt. GREEN/ black in the drivers kick panel. For the passenger door, use Lt. blue in the passenger kick panel. The rear doors have pin switches. Must go to each rear pin switch and diode isolate the factory wire a six amp diode. For rear door trigger attach between the diode and the pin switch. Each door trigger wire must be diode isolated to the alarm. *3 Only available on the wagon models.