wiring diagram for a 1996 dodge ram 3500
Printed From: the12volt.comForum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=60282
Printed Date: May 31, 2024 at 10:21 PM
Topic: wiring diagram for a 1996 dodge ram 3500
Posted By: monte561
Subject: wiring diagram for a 1996 dodge ram 3500
Date Posted: July 28, 2005 at 2:20 PM
Replies:
Posted By: thepencil
Date Posted: July 28, 2005 at 2:40 PM
Hope the diagram will help you out. Are you sure it's 24V? 
I've never seen one.
DIRECTWIRE™ WIRING INFORMATION - DODGE / RAM PICKUP / 1996 / Remote Start
12volts red or pink/black + ignition harness
Starter yellow or blu/yel + ignition harness
Second Starter
Ignition dk. blue + ignition harness
Second Ignition
Third Ignition
Accessory BLACK/ orange + ignition harness
Second Accessory
Keysense
Power Lock ORANGE / purple 5wi lt blue plug in driver kick
Power Unlock pink/purple 5wi lt blue plug in driver kick
Lock Motor
Unlock Motor
Parking Lights+ BLACK / YELLOW yellow plug in driver kick
Parking Lights-
Hazards
Turn Signal(L)
Turn Signal(R)
Reverse Light
Door Trigger yellow - yellow plug in driver kick
Dome Supervision use door trigger
Trunk/Hatch Pin
Hood Pin
Trunk/Hatch Release
Power Sliding Door
Factory Alarm Arm
Factory Alarm Disarm
Disarm No Unlock
Tachometer gry/blk, blk/gry AC ignition coil
Notes: Also located as gray/blue at large plug through firewall on drivers side at highest point of firewall, also gray/blue at cluster.
Wait to start ORANGE / black - PCM
Notes: The PCM (Powertrain Control Module) is on the passenger side firewall under the hood.
Brake Wire WHITE/ brown + brake pedal switch
Parking Brake
Horn Trigger dk. GREEN/ red + relay at fuse box
Notes: Also BLACK/ red (-) at column or relay.
Memory Seat 1
Memory Seat 2
Memory Seat 3
Interface Module: Category:
Immobilizer Bypass Required:
No Type:
N/A
Part #: N/A
Notes:
This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.
Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.
-------------
Be careful whose advice you buy, but be patient with those who supply it.
I've never seen one.
DIRECTWIRE™ WIRING INFORMATION - DODGE / RAM PICKUP / 1996 / Remote Start
12volts red or pink/black + ignition harness
Starter yellow or blu/yel + ignition harness
Second Starter
Ignition dk. blue + ignition harness
Second Ignition
Third Ignition
Accessory BLACK/ orange + ignition harness
Second Accessory
Keysense
Power Lock ORANGE / purple 5wi lt blue plug in driver kick
Power Unlock pink/purple 5wi lt blue plug in driver kick
Lock Motor
Unlock Motor
Parking Lights+ BLACK / YELLOW yellow plug in driver kick
Parking Lights-
Hazards
Turn Signal(L)
Turn Signal(R)
Reverse Light
Door Trigger yellow - yellow plug in driver kick
Dome Supervision use door trigger
Trunk/Hatch Pin
Hood Pin
Trunk/Hatch Release
Power Sliding Door
Factory Alarm Arm
Factory Alarm Disarm
Disarm No Unlock
Tachometer gry/blk, blk/gry AC ignition coil
Notes: Also located as gray/blue at large plug through firewall on drivers side at highest point of firewall, also gray/blue at cluster.
Wait to start ORANGE / black - PCM
Notes: The PCM (Powertrain Control Module) is on the passenger side firewall under the hood.
Brake Wire WHITE/ brown + brake pedal switch
Parking Brake
Horn Trigger dk. GREEN/ red + relay at fuse box
Notes: Also BLACK/ red (-) at column or relay.
Memory Seat 1
Memory Seat 2
Memory Seat 3
Interface Module: Category:
Immobilizer Bypass Required:
No Type:
N/A
Part #: N/A
Notes:
This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.
Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.
-------------
Be careful whose advice you buy, but be patient with those who supply it.
Posted By: monte561
Date Posted: July 28, 2005 at 4:49 PM
Posted By: thepencil
Date Posted: July 29, 2005 at 11:50 AM
You are quite welcome.
-------------
Be careful whose advice you buy, but be patient with those who supply it.
-------------
Be careful whose advice you buy, but be patient with those who supply it.