DEI 530T Window

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=6036
Printed Date: May 16, 2024 at 4:24 PM

Topic: DEI 530T Window

Posted By: rrspyder
Subject: DEI 530T Window
Date Posted: November 29, 2002 at 6:12 PM

I have a question concerning the DEI 530T. I have a 2002 Mustang GT and I am trying to connect this module up to my system. The manual states that the module should be connected between the motor and the switch. From what I understand this can be easily done on the driver side but I am not sure how to connect it between the passenger switch and motor w/ out running wires across the car. Can i simply connect it to the wires that run from the master driver switch to the passenger side? Which for my car are tan/blu - wht/yel I believe. Will this hinder the module in anyway or prevent it from detecting when to stop rolling up the window?

Thanks for the help,

Kyle

Replies:

Posted By: christophe
Date Posted: November 29, 2002 at 6:19 PM

There is no problem in doing that. The only thing you'll miss out on is auto up and down control from the pass. side switch. Otherwise everything works great.

Posted By: cpgoose
Date Posted: December 02, 2002 at 7:39 AM

hi.

I actually did run wires across the car to the passenger door. So....I have the wires going from the 530t into the driver's door, and then wires going from the 530t all the way across into the passenger door. This way, I have 1-touch control from ALL the switches (the 2 switches for both doors on the driver's side, as well as the 1 switch on the passenger door for the passenger window). It's a little more wire, but it's awesome once you're done!