2003 toyota runner power locks
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=60728
Printed Date: May 17, 2024 at 6:00 PM
Topic: 2003 toyota runner power locks
Posted By: Eric Decastro
Subject: 2003 toyota runner power locks
Date Posted: August 05, 2005 at 12:07 AM
the wiring diagram i got here is wrong, it says 99-03 but it should be 99-02. the 04 wiring diagram is correct.
but, here is my problem, it says:
Power Lock blue - driver kick, 18 pin plug
Notes: Meter the wire while turning the key in the driver door key cylinder.
Power Unlock green (double pulse) - driver kick, 18 pin plug
it doesn't say (-) or (+)
the only 18pin connector I found didn't have a green or blue. and couldn't get a good reading on the pins that were green with a stripe and blue with a stripe.
has anyone done an alarm on a 2003-2004 runner? plz. thanks in advance folks.
Replies:
Posted By: azdoi
Date Posted: August 05, 2005 at 12:45 AM
Try blue/white for lock in pin #4, and blue/orange for unlock in pin #5 with a double pulse
Posted By: Eric Decastro
Date Posted: August 05, 2005 at 12:59 AM
great thanks for the quick reply, this is the blue connector below the small yellow connector. also can i jus run it from the (-)250Ma output from the alarm (assuming this is the trigger for the relay) or do I use my relay pack? thanks.
Posted By: Velocity Motors
Date Posted: August 05, 2005 at 8:25 AM
If you have a relay pack, use it, but in most cases the 250mA is good enough.
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
|