Print Page | Close Window

Clifford 3.5 RS problem

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=60838
Printed Date: July 05, 2025 at 2:48 AM


Topic: Clifford 3.5 RS problem

Posted By: dnt408
Subject: Clifford 3.5 RS problem
Date Posted: August 06, 2005 at 7:08 PM

Okay, I think the manual is out of date or incorrect. Anyways if I read the step by step instruction on the primary harness, the H1/6 Blue. that wire is suppose to be a multiplex zone 4. So I decided to install my 508D prox sensor there. But the problem is that it's showing up on my remote as a trunk. Not a problem about that but won't do warn, only Full Trigger. I look in the back where the picture is and that wire is for trunk, which makes sense now because it's wouldn't do warn and full.

Anyways, which wire would I need to use in order to trigger senor 2 on my remote. I see that the shock sensor is senor 1 on my remote



Replies:

Posted By: dare_ds69
Date Posted: August 08, 2005 at 6:14 AM

the shock sensor wires has an extra green wire wich is not conected to anything thas the wire that you need.posted_image



-------------
how own your mind, control your life.
MECP certified. always use a DMM




Print Page | Close Window