hi i got a comando alarm with remote start i want to install on my 97 cavalier. i was wondering if anybody has a wire diagram for this vehicle.
-------------
thanks for the help
haze
| Constant 12 volts | RED & RED | IGNITION SWITCH HARNESS |
| Ignition 12 volts | PINK | IGNITION SWITCH HARNESS |
| Starter | YELLOW | IGNITION SWITCH HARNESS |
| Dome Light | L GREEN/ BLACK (DR) & | L BLUE (ALL DOORS) AT CONV. CENTER * |
| Trunk Pin Switch | N/A | |
| Parking Lamp | BROWN (+) | AT HEADLIGHT SWITCH |
| Power Lock | L BLUE | DRIVER KICK (W/O OEM KEYLESS) ** |
| Power Unlock | WHITE | PANEL (W/OEM KEYLESS)** |
* L GREEN/ BLACK (-) Covers Driver Door Only. L BLUE (-) Covers All Other Doors. Diode Isolation Needed, Cathode (Band) Side Of Diode Faces OEM Wires. Convenience Center Module Located Above Passenger Kick Panel.
** Without OEM Keyless Door Lock Wires MUST Be Tested From PASSENGER Switch!!
W/O OEM Keyless ..... Reversal Rest At Ground Door Locks.
With OEM Keyless ..... Positive Pulse Door Locks
| Accessories |
| Window Up | D\ D BLUE P\ L BLUE D\ D GREEN P\ L GREEN @ MAIN SWITCH | |
| Window Down | F/ BROWN F/ TAN R/ PURPLE R/ PURPLE | |
| Ign Key Warn | L GREEN (-) | IGNITION SWITCH HARNESS |
| Trunk Release | BLACK/ WHITE (+) | AT OEM KEYLESS MODULE * |
| OEM Horn | BLACK (-) | STEERING COLUMN HARNESS |
| Headlights | D BLUE (-) (LO) & | PINK (-) (HI) AT HEADLIGHT SWITCH |
| OEM Alarm Arm | N/A | |
| OEM Alarm Disarm | N/A | |
Reversal Rest At Ground Power Window Circuit
. * With OEM Keyless Only!! OEM Keyless Module Located On Drivers Side Of Trunk.
| Remote Start |
| Tach Signal | WHITE | AT POWERTRAIN CONTROL MODULE ** |
| Ignition #2 | ORANGE | IGNITION SWITCH HARNESS (HEAT/AC) |
| Ignition #3 | WHITE | IGNITION SW. HARNESS (PCM & CLUSTER)* |
| Accessory | BROWN | IGNITION SWITCH HARNESS |
| Neutral Safety | NOT GROUNDING TYPE - | OEM SWITCH OPENS STARTER CIRCUIT |
| Brake Light | WHITE (+) | AT SWITCH ABOVE BRAKE PEDAL |
| Reverse Light | L GREEN (+) | AT SWITCH ON TRANSAXLE |
| Rear Window Defrost | N/A | TIMER BUILT INTO SWITCH |
* 2.4L Engine Tach Wire Is WHITE At Powertrain Control Module (PCM). 2.2L Engine Tach Wire Is WHITE or ORANGE At PCM Or Ignition Control Module. Both Wires Are 2 Cylinder Signals Each. PCM On Both Located In Passenger Front Fender. Ignition Control Module On 2.2L Located On Rear Center Of Engine. ** WHITE Wire Powers Powertrain Control Module (PCM) & Instrument Cluster.
G.M. Passlock Diagram.
-------------
MO
Don't Learn from Others Mistakes
You Might Be the One That Knows.
thanx mo your a blessing from god. i was starting to pull my hair out by the roots. with this diagram i'll be able to do my task at hand. again thanx and god bless
-------------
thanks for the help
haze