Window Module Wiring Check

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=60977
Printed Date: May 10, 2025 at 1:39 AM

Topic: Window Module Wiring Check

Posted By: cs015271
Subject: Window Module Wiring Check
Date Posted: August 08, 2005 at 10:47 PM

I recently purchased a window module, and had a question on the wiring diagram they suplied. I am familiar with window modules but needed some clarificaton on this one:

10-Pin Harness
M1- blue
S1- white
M2- blue
S2- white
M3- brown
S3- white
M4- brown (rollup motor)
S4- white (rollup switch)
(+)- red
(-)- black

3-Pin Harness
N(acc+)-white
M(to central lock)-black(-)
K(lock on)-red(+)

My question is with the 3-pin connector . which wire is used as the activation wire that i should hook up to my alarms ground when armed wire. Or how are these three wires used?

the module being used is named trackpro power window control module tp-4wl

Lastly I'm am installing this item on a 2004 Ford Explorer, will it be nessasary to go to each motor in each door for wiring, or can i get to these wires at the main switch?

Replies:

Posted By: dare_ds69
Date Posted: August 09, 2005 at 6:12 AM

all depend in what kind of car are you doing, some cars you have to go to each door, some does't

it looks like it works with lock, so everytime you press lock is going to roll up the windows, white wire is to prevent the windows going up while you driving if you press lock.

-------------
how own your mind, control your life.
MECP certified. always use a DMM

Posted By: cs015271
Date Posted: August 09, 2005 at 10:41 AM

Thankyou

Since i provided that The vehicle is a 2004 Ford Explorer, does anyone know if i have to go directly to each motor wire or can i use the wires directy at the main switch.

Posted By: cs015271
Date Posted: August 09, 2005 at 10:55 AM

Thankyou

Since i provided that The vehicle is a 2004 Ford Explorer, does anyone know if i have to go directly to each motor wire or can i use the wires directy at the main switch.

Posted By: wooley59
Date Posted: September 16, 2005 at 5:43 PM

Did anyone figure this out yet? I have the same unit. I also need to know what to do with the three wires. I have a Code Alarm in a 2002 Ford Taurus and want the windows to roll up when I arm the alarm. Do all three wires need to be used?

-------------
W.D.W.