Viper 791 Problem

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=61319
Printed Date: May 05, 2024 at 6:05 AM

Topic: Viper 791 Problem

Posted By: Geoff897
Subject: Viper 791 Problem
Date Posted: August 14, 2005 at 5:59 AM

Hi all i just got my alarm installed the other day it was working fine
i pulled the stereo out and now i have the led on constantly
when i lock the car the doors lock but the windows dont go up.
when i start the car the light goes out and none of the sensors work

Any ideas on the problem??

Thank you
Geoff

Replies:

Posted By: swamprat323
Date Posted: August 14, 2005 at 9:38 AM

sounds like in valet mode. form remote: open a door, hit lock then unlock and lock again. the led will go out.

Posted By: Geoff897
Date Posted: August 14, 2005 at 3:56 PM

Thanks ill give that a go

Also 1 of my back windows doesnt close all the way up i needed to lock and unlock the car to get it to close all the way up any ideas.

Its in a Subaru liberty 01

Posted By: Geoff897
Date Posted: August 17, 2005 at 6:31 AM

Hi thanks swamprat323 thats what the poblem was

Posted By: topspoiler
Date Posted: August 22, 2005 at 4:05 AM

I think you have to change the resistant on the window module.

Posted By: topspoiler
Date Posted: August 22, 2005 at 4:06 AM

I think you have to change the resistant on the window module.

Posted By: tillithz
Date Posted: August 22, 2005 at 11:24 AM

well if its just ONE window on the two window module i would think that instead of the resistance being raised you should figure out what is dragging that one window. such as maybe an accident or moisture, or something physical inside the door causing the window not to roll up properly

Print Page | Close Window