Print Page | Close Window

calterm igniton lock

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=61695
Printed Date: July 06, 2025 at 8:06 AM


Topic: calterm igniton lock

Posted By: theforumguy
Subject: calterm igniton lock
Date Posted: August 19, 2005 at 4:38 PM

posted_image

hey any of you guys\gals buy one of these things. i dont know how do install it. the three terminals are for batt, ign, forgot third one and theres one more in the middle for starter. if any you know plz let me know ty




Replies:

Posted By: CutDog504
Date Posted: August 20, 2005 at 1:46 AM
The third is for accy. You would basically wire this up just like a remote start. I put one of these on an old chevy work van a while back like a 78 or 79 with the ign switch in the dash. I just replaced the factory switch with this one. Just get some ring terminals and connect the appropriate wire to the corresponding terminals on the switch(12v to batt, ign to ign, starter to starter, accy to accy) If you have more than one ign wire, just use a relay.


Print Page | Close Window