Alarm Trouble

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=61734
Printed Date: July 06, 2025 at 10:52 AM

Topic: Alarm Trouble

Posted By: BongMong
Subject: Alarm Trouble
Date Posted: August 20, 2005 at 10:01 AM

i bought a remote start alarm from ebay (LF-Q205A)

i paid a electricain to fit it, ihedone a good job spite the unit was broken.

i bought another unit from ebay and swapped the LED / Siren / Unit.

the alarm worked fine, every function* until i zip tied the loom and relocated the LED to my hazard switch..

the alarm takes 10secs to arm the car. i press arm and my centrel locking locks, after ten seconds my alarm goes off.

i try remote start, my car starts first time, but now starter motor keeps trien to start my car as it is already running.

i have disconnected the microsencor, shock sensor, LED, centrel locking, engine start & cut off looms, i arm the alarm and it still goes off after 10 secs spite only having the power loom wired into it.

any ideas?

Replies:

Posted By: mo12v
Date Posted: August 20, 2005 at 5:04 PM

Did you set it for TACH or Volts??
Did you program anything?

-------------
MO

Don't Learn from Others Mistakes
You Might Be the One That Knows.

Posted By: Velocity Motors
Date Posted: August 20, 2005 at 5:15 PM

The door trigger's are seeing the dome light delay or the installer hooked up the wrong door trigger sensor on the system to the car. The starter problems sounds like a tach programming issue as mo12v stated above. You will need to program the tach signal properly in order for the remote starter to acknowledge the vehicle has started.

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA