1995 Volvo 850 lock/unlock
Printed From: the12volt.comForum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=61963
Printed Date: July 07, 2025 at 7:36 PM
Topic: 1995 Volvo 850 lock/unlock
Posted By: equate
Subject: 1995 Volvo 850 lock/unlock
Date Posted: August 24, 2005 at 11:29 AM
Replies:
Posted By: thepencil
Date Posted: August 24, 2005 at 12:06 PM
Find and use these wire instead.
Power Lock yellow/gray - drivers kick panel
Power Unlock gray/red - drivers kick panel
DIRECTWIRE™ WIRING INFORMATION - VOLVO / 850 / 1995 / Keyless Entry
12volts red + plastic-tube harness
Starter GREEN/ red + located behind the
Ignition blue/red + relays near firewall
Power Lock yellow/gray - drivers kick panel
Power Unlock gray/red - drivers kick panel
Lock Motor
Unlock Motor
Parking Lights+ white at switch
Notes: Use relay to isolate switch side of wire to prevent car from unlocking on arm.
Parking Lights-
Hazards
Turn Signal(L)
Turn Signal(R)
Door Trigger yellow/white - near hood release
Notes: Do not use the pink/black domelight wire since it is affected by the delay and turns off 60 seconds after the door is opened.
Dome Supervision
Trunk/Hatch Release
Power Sliding Door
Factory Alarm Arm arms with lock
Factory Alarm Disarm blue/brown - driver kick panel
Notes: To disarm the factory alarm, must trigger the blue/brown factory alarm disarm wire, and the gray/red unlock wire at the same time.
Disarm No Unlock
Horn Trigger yellow/black - steering column
Notes: horn only works with the key in the accessory or run position.
Memory Seat 1
Memory Seat 2
Memory Seat 3
Interface Module: Category:
Immobilizer Bypass Required:
No Type:
N/A
Part #: N/A
Notes:
This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.
Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.
-------------
Be careful whose advice you buy, but be patient with those who supply it.
Power Lock yellow/gray - drivers kick panel
Power Unlock gray/red - drivers kick panel
DIRECTWIRE™ WIRING INFORMATION - VOLVO / 850 / 1995 / Keyless Entry
12volts red + plastic-tube harness
Starter GREEN/ red + located behind the
Ignition blue/red + relays near firewall
Power Lock yellow/gray - drivers kick panel
Power Unlock gray/red - drivers kick panel
Lock Motor
Unlock Motor
Parking Lights+ white at switch
Notes: Use relay to isolate switch side of wire to prevent car from unlocking on arm.
Parking Lights-
Hazards
Turn Signal(L)
Turn Signal(R)
Door Trigger yellow/white - near hood release
Notes: Do not use the pink/black domelight wire since it is affected by the delay and turns off 60 seconds after the door is opened.
Dome Supervision
Trunk/Hatch Release
Power Sliding Door
Factory Alarm Arm arms with lock
Factory Alarm Disarm blue/brown - driver kick panel
Notes: To disarm the factory alarm, must trigger the blue/brown factory alarm disarm wire, and the gray/red unlock wire at the same time.
Disarm No Unlock
Horn Trigger yellow/black - steering column
Notes: horn only works with the key in the accessory or run position.
Memory Seat 1
Memory Seat 2
Memory Seat 3
Interface Module: Category:
Immobilizer Bypass Required:
No Type:
N/A
Part #: N/A
Notes:
This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.
Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.
-------------
Be careful whose advice you buy, but be patient with those who supply it.
Posted By: equate
Date Posted: August 24, 2005 at 11:56 PM