Clifford central locking on a Nissan

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=61987
Printed Date: May 19, 2024 at 10:05 AM

Topic: Clifford central locking on a Nissan

Posted By: xjr41
Subject: Clifford central locking on a Nissan
Date Posted: August 24, 2005 at 7:24 PM

Hi guys,

I'm hoping someone can help me on my first alarm install.

Installing a Concept 300 on a UK Nissan 200SX (240SX in thr US). The car has no actuator in drivers door, only a switch, and a single wire lock/unlock system.

I have bought a 2 wire actuator to lock/unlock the drivers door. My question is how do I wire it in? Where do I connect the two wires on the actuator and how do I connect to the single wire locking system. I'm guessing that I need to use relays and have read the relays section, but have now got myself so confused I don't know where to go next!

Please help.

Thanks,

Steve.

Replies:

Posted By: MM3STB
Date Posted: September 07, 2005 at 5:20 AM

Hi,

Give this a try. Hope it helps

https://www.directechs.com/guides/manuals/ig/clifford/doorlocks_install.pdf

Regards

Richard

Posted By: ringojam
Date Posted: September 07, 2005 at 3:13 PM

This is a very simple install.Use a two wire acuator in the drivers door run the wires to under the dash . There is a black box in the upper left side of steering column. If you lock and unlock thedoor you can hear it click. Most of these boxes can be negative pulsed.Find the negative pulse in the box and hook the alarm to them,this will only pulse the passenger door. Then find the output to the pass door from the box will pulse pos when lock and unlock then hook the acuator wires to them. This way no relays and when you lock and un lock from the factory switch all doors will work.