programming a Code Alarm remote

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=62111
Printed Date: July 12, 2025 at 10:44 AM

Topic: programming a Code Alarm remote

Posted By: fredzeppelin256
Subject: programming a Code Alarm remote
Date Posted: August 26, 2005 at 8:21 PM

Hey y'all ! A couple of years ago, my remote for my Code Alarm security system broke, and I just got a used remote from a friend who used to have the same exact system. The problem is, the previous owner had the system installed and I don't have any of the installation manuals. I was told to check out the forums on this site, so I signed up today. Hope somebody can help me!

I know there is a specific sequence you have to flip the valet switch, so my question to you all is.....does anyone know the sequence?

If it helps, the remote's FCC ID is GOH-MX1. Thanks everyone!

Replies:

Posted By: mo12v
Date Posted: August 26, 2005 at 9:56 PM

GOH-MX1........doesn't show up on FCC check.........

-------------
MO

Don't Learn from Others Mistakes
You Might Be the One That Knows.

Posted By: vicko6369
Date Posted: August 27, 2005 at 4:46 PM

try this: ignition on, door open (make sure the dome light is on) press an hold the valet switch for about 10 secs, till you hear 3 chirps, then while still holding the valet press the lock button on your remote, that should be it