Viper 791install
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=62218
Printed Date: April 28, 2024 at 4:49 AM
Topic: Viper 791install
Posted By: 03taurus
Subject: Viper 791install
Date Posted: September 05, 2005 at 8:42 AM
I am in the middle of installing this alarm and I can not get the unlock to operate at all. I would like the progressive door unlock that the factory alarm did. The doors lock fine with the viper. I did not hook up any wires to the door lock motors at all. I only used the power lock and power unlock wires. I don't know what to hook the motor wires to. Also, the door trigger wires don't work. Another issue, is the puddle lamps on the mirrors don't turn on with disarming as well as the headlight and parking lights don't stay on like they did with the factroy disarming. I have automatic headlights on this car from the factory. Any help would be greatly appreciated. And thanks to everyone who worked so hard to get this running again in record time and stay safe.
Replies:
Posted By: 03taurus
Date Posted: September 05, 2005 at 10:10 AM
The manual says nothing about unlock motor and lock motor, it only says about the power lock and power unlock. Am I missing something here? The power lock and power unlock are (-), and the unlock motor and lock motor are (+).
Posted By: 03taurus
Date Posted: September 06, 2005 at 1:38 AM
Ok I finally got the the lock and unlock to work correctly, by using diodes. I hooked the unlock to the 2nd. unlock channel so I can have progresive unlocking. Now I just need to find the single wire for the drivers door for the first unlock. Also, no luck yet on the light sitution either. Is there anyone here that has done progresive unlocking on a 2003 Taurus or am I a rare breed?
Posted By: ccroadshop99031
Date Posted: September 06, 2005 at 4:02 AM
if you cant find it you can 5 wire the drivers door motor and use that to the first unlock output then the rest of the doors to the 2nd unlock
Posted By: 03taurus
Date Posted: September 06, 2005 at 8:35 PM
How do you five wire a door? Also, the only wires I find that work with the door trigger, only work with the ignition in the on position.
Posted By: blazeronspokes
Date Posted: September 07, 2005 at 7:38 AM
the easiest way is going to be with a 451m doorlock module. the instructions inside the package should show you the basic 5 wire hook up, you just need to go to directechs and find the colors for the lock motor.
Posted By: profuse007
Date Posted: September 07, 2005 at 8:49 AM
| UNLOCK MOTOR|RED / white | 5wi |top plug of fusebox
FORD, TAURUS, 2003, Door Trigger
This wire controls the door ajar indicator on the dash, must cut the wire and diode isolate it from the instrument cluster. Can also use individual negative door trigger wires in the 26 pin plug at the GEM. They are: yellow/black (LF), gray/red (RF), lt. GREEN/ YELLOW (LR), and pink/lt. blue (RR).
| DOME SUPERVISION|BLACK/ lt. blue |+ |top plug of fusebox
-------------
Houston,TX
"The two most common elements in the universe are H+ and stupidity" (Ellison).
|